Search Results

Search results 1-12 of 12.

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • ...und deaktiviere mal DiSEqC und setzt die "LNB-Versorgung" auf "normal".

  • Du musst jedem Receiver eine eigene Unicable-Frequenz zuordnen. Ich vermute, Du hast beim TV eine der Frequenzen verwendet, die Du beim iCord schon benutzt hast.

  • cannot switch it on

    dau0815 - - iCord HD

    Post

    Quote from anjaunddirk: “Don't know, if "capacitors" ist the right word !” But me: Yes, it is.

  • starting system problem

    dau0815 - - iCord HD

    Post

    Your iCord could have the old known problem: --> defective electrolytic capacitors <--. Please have a look at them, exchange them and you will be happy again.

  • Factory Reset

    dau0815 - - iCord HD

    Post

    First I pushed your question into the "Englich iCord Loenge". Then a question: You posted in the section for the iCord-HD+ (with Plus) and writes over an iCord-HD (without Plus). I think the second one is the correct one. I'm right? If so: Did you save your channel list to an USB device before you did a factory reset? If yes, you only must restore it to the iCord. Then all settings are back. If not, you must setup your antrenna configuration according to your constellation before starting the ch…

  • date problem on my humax pdricord

    dau0815 - - PDR iCord HD

    Post

    Date and time will be set automatically if a tv channel is visible. You cannot set it manually.

  • epg

    dau0815 - - iCord HD

    Post

    No. The iCord-HD is too old, that there would come something new as this. You only can use the SI-EPG, that will be broadcasted directly by the tv stations, if they do. You must switch to one station and after a few seconds you should see the EPG of this station. If you leave this station, the data will not be cleared and stay present.

  • You're welcome. Please keep us informed.

  • It's not possible to access the harddisk of the iCordHD via USB connection. But I have another idea: If you really have the "old" iCordHD, you can use MiniRootFS, a firmware extension of the forum team, on it. This can run a SAMBA server. If you can access a SAMBA share from the Foxsat, this could work. But pay attention. I do not know, how the iCord reatcs on foreign files on its hard drive!

  • Playing recorded videos on PC

    dau0815 - - iCord HD+ Plus

    Post

    HD+ recordings, if they are, are always encrypted and not playable outside the iCord. From which channel are the recordings?

  • Quote from SAT-ShopHN: “Receiver needs an Service.” Ok, you could be right.

  • I would try to update the firmware through the internet (Humax Portal). For this, you need a connection on the iCord to a router, that provides an internet connection.